1995 jeep cherokee part time 4wd light

drman · #1 01-08-2007, 05:25 PM

I just had a new transfer case put on my baby and 3 hours and 40 miles later my dash light for "PARTTIME" flickered then remained on. I stopped and ran through all positions and everything seems to be working properly (2wd,4h,N, and 4 L).
Any ideas on what may be causing this? Where this particular sensor may be? Should I sue?

AlohaBra · #2 01-08-2007, 07:30 PM

Check at the transfer case switch first. Disconnect it and see if the light goes out.

There could be a wire pinched and grounded or shorted.

drman · #3 01-08-2007, 07:51 PM

I did that, to no avail. the light stil stayed on. Any tips on resetting the computer? would that help?

AlohaBra · #4 01-08-2007, 08:13 PM

I believe your wire harness is shorting or grounding.

I just checked the wiring diagram for that. I only have one for the 2000 MY.

Disconnect the battery to reset the computer...but don't think that is it.

joe8918 · #5 01-09-2007, 07:27 AM

not to take away from drman's question but when you put your XJ into 4WD is there to be a light that illuminates on the dash? I have been meaning to post this question but I have done it. I have put mine into 4WD but there has been no light that's gone on...sorry to go off topic as I hope you can help him solve his light issue.

AlohaBra · #6 01-09-2007, 10:56 AM

Here is a diagram to look at...00MY...

http://www.dua1.com/AdminFiles/Jeep/...J_4WD_lite.pdf

POST REPLY TO THIS THREAD