|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
11-25-2006, 11:39 PM
|
|||
|
|||
|
96 legacy abs problems....
i have a 96 legacy wagon "L" with 4wheel disk and 4wheel abs (5.3i) and i'm having trouble getting codes from the abs computer any suggestions?? it is really close to snowing here and i would like to fix the abs b4 it snows!
__________________
Crxce- theoretically if u laid a starter on a table and hooked up the wires would it run??? BLU CIVIC- no...it doesn't have any legs 
|
|
#2
11-30-2006, 11:25 PM
|
||||
|
||||
|
Re: 96 legacy abs problems....
so what is it doing or not doing?
chances are theres a bad sensor
__________________
Subaru Legacy International
|
|
#3
12-06-2006, 10:15 PM
|
|||
|
|||
|
Re: 96 legacy abs problems....
ok i managed to get code 32, code 51 out of the blinking light any suggestions on how to fix this???
__________________
Crxce- theoretically if u laid a starter on a table and hooked up the wires would it run??? BLU CIVIC- no...it doesn't have any legs
|
|
#4
12-17-2006, 12:26 PM
|
|||
|
|||
|
Re: 96 legacy abs problems....
According to my manual, 32 means faulty solenoid valve circuit in hydraulic unit(front right outlet valve). 51 means faulty valve relay.
My question for you is, how did you get it to flash the codes? My '96 Outback doesn't seem to have the wires that the manual picture shows.
|
|
#5
09-29-2008, 11:17 PM
|
|||
|
|||
|
Re: 96 legacy abs problems....
i found the problem i bought a HCU and a pump and turned out the wires on the bottom of the sylenoid were bad and the plug for the front left sensors is bad so problems solved... now if i can only fix my SRS problems!
__________________
Crxce- theoretically if u laid a starter on a table and hooked up the wires would it run??? BLU CIVIC- no...it doesn't have any legs
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
