|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
10-02-2006, 11:36 AM
|
||||
|
||||
1997 1500 350 5.7
 when i start the truck, it takes a few seconds for the oil press. guage to build like it does after an oil change and while driving the needle is all over the place. anyone got any ideas?
|
|
#2
10-08-2006, 09:39 PM
|
|||
|
|||
|
Re: 1997 1500 350 5.7
I would remove the sending unit and install a pressure gauge. Sometimes the sending unit goes bad. It could possibly be a bad ground. Unless you veryify it with a gauge you are taking a chance buying parts.
|
|
#3
10-15-2006, 07:40 PM
|
|||
|
|||
|
Re: 1997 1500 350 5.7
THere is a service bulletin on those clusters doing just that.. it has to do with a ground strap in back of the cluster.. I'll see if I can dig it up
__________________
Mark Mcknight Elmvale Truck & 4x4 (705)-715-7867 Elmvale, Ontario 87 Mustang GT, 5.0L 5 spd, MSD ignition, BBK tubes, flowmasters, tri-ax shifter, 4.10 gears 69 Charger SE, stroked & poked 383,727 over 550rwhp 86 Chevy 2500 4x4 Plow truck, 350/TH400, 8ft fisher plow
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
