|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
10-01-2006, 11:14 PM
|
|||
|
|||
|
i got the codes, now how do i fix them?
ok i just ran a self test (with paper clip) on my 94 Blazer 4.3 code W automatic 2WD blazer.......... here are the codes i got:
23: which is Manifold Absolute Temperature (MAT) sensor or circuit / low temp 66: which is Air conditioning pressure sensor circuit. Does anyone know how to fix any of these?? thanks in advance! Also could any of these cause a sluggish start in Drive? It seems fine the second i step on the gas, then about a second later it seems to loose its power and kinda bog down.......... Is there anyway to pull the ABS codes on a OBD1 connector?? I think this may be the cause of the above problem. Thanks, Steve 
|
|
#2
10-01-2006, 11:19 PM
|
|||
|
|||
|
Re: i got the codes, now how do i fix them?
could a bad PCV cause code 23?? because i know i need a new one.
|
|
#3
10-02-2006, 11:28 AM
|
|||
|
|||
|
Re: i got the codes, now how do i fix them?
no one knows???
|
|
#4
10-02-2006, 08:23 PM
|
|||
|
|||
|
Re: i got the codes, now how do i fix them?
wow...........
|
|
#5
10-02-2006, 10:35 PM
|
||||
|
||||
|
Re: i got the codes, now how do i fix them?
ok dude you really need to chill if u know u need a new pcv valve replace it and see if the code goes away all of ur other posts are the same way people are more willing to help you if you just relax
__________________
and yes i am a ASE Master Auto Technician 1996 chevrolet silverado 5.7L 4x4 nothin but a k&n for now i just got it
|
|
#6
10-02-2006, 11:50 PM
|
|||
|
|||
|
Re: i got the codes, now how do i fix them?
I was reading my Haynes manual and it said codes 37 38 39 and 58-82 are transmission codes and represent internal transmission problems and should be left to a dealer service department or transmission repair shop. Anyone know about this?
Im not sure what the site was that i saw code 66 was a air conditioning pressure sensor.......
|
|
#7
10-05-2006, 09:46 AM
|
|||
|
|||
|
Re: i got the codes, now how do i fix them?
wow i figured it out. There is a lot of help on the Blazer forum here......
 the code 66 was for my 3-2 Control Solenoid so i got it out last night, now i have to go get a new one.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
