Name that connector! Pics inside..

[NickF829]

Ok, so picture the harness the connects to each individual injector(3.1 v6). Attached to this harness is a large, 3 female ported connector, it is green. Attached is the pic. I can't figure out where this thing goes to save my life. Any takers?

[tractorboy]

Ect Sensor , Iac , Egr , Map
OR MAF IF THE CABLE IS LONG ENOUGH
IGNITION COILS
CAMSHAFT POSITION SENSOR
OX SENSOR HEATED HAS THRE TERMINALS RIGHT.

I THINK IT IS THE MAP

[NickF829]

ok so next question, do you have a picture of the map sensor? i put everything back together, just ran that connector to the outside toward the ign. coils, now I have a (1)empty vacuum inlet, (2)a 3 prong green connector(pictured), (3) a empty mounting bracket attached to the rear upper intake bolts and (4)a tube connected to the air intake leading to this empty spot where the MAP sensor should be. so i assume i'm missing the sensor.

this is what i get for walking away from this POS for 2 months before finally finishing it

[tractorboy]

Yes, sounds like you are missing the MAP sensor. Do you have any parts laying around? left over ? a new one probably at auto zone or pep boys should not cost much. Don't forget a gasket too, if it needs one. A junk yard may have one also. Don't run the car with out, if it will start.

[NickF829]

found it, it was in front of me the whole time on my welding bench, it didn't look like i expected though. thanks for the help

[tractorboy]

glad to have helped