need help high beams

[kimbergross]

my high beam are both out i change bulbs and light switch . any buddie know what is wrong or what to check thank for any help i check the fuse too. and they are all good.

[94VL]

Dimmer switch?

[jakegday]

by dimmer switch i think he means the switch you use to go back and forth from regular to high beams, is that the switch you replaced??

[kimbergross]

Originally Posted by jakegday

by dimmer switch i think he means the switch you use to go back and forth from regular to high beams, is that the switch you replaced??

yes that is the one i replaced

[kimbergross]

Originally Posted by 94VL

Dimmer switch?

i replaced that thanks

[mstr3000]

did you check the connectors at the back of the bulbs? if they are not properly seated, it will cause that problem

[94VL]

Do you have those High performance high wattage "off road use only" bulbs? If so,the amp draw these take can melt wires and ruin sockets.

[kimbergross]

Originally Posted by mstr3000

did you check the connectors at the back of the bulbs? if they are not properly seated, it will cause that problem

yes i check connector i even re check bulp with my 1997 and they worked in it but not in the 1999 thank for info kimber

[kimbergross]

Originally Posted by 94VL

Do you have those High performance high wattage "off road use only" bulbs? If so,the amp draw these take can melt wires and ruin sockets.

no i do not have high performance bulbs thanks kimber

[Cap0ni]

take a volt meter to them and see if your getting anything through. trouble it back untill you find where tyour not getting them switched. you may have a short or faulty wiring somewhere not always a switch.

its been awhile since i had the column apart but i believe its the brown wire in your assembly inside the console, a voltmeter or wiggy will tell you for sure tho, since youve already replaced the bulbs and switches check the wiring.

[kimbergross]

Originally Posted by Cap0ni

take a volt meter to them and see if your getting anything through. trouble it back untill you find where tyour not getting them switched. you may have a short or faulty wiring somewhere not always a switch.

its been awhile since i had the column apart but i believe its the brown wire in your assembly inside the console, a voltmeter or wiggy will tell you for sure tho, since youve already replaced the bulbs and switches check the wiring.

i dont know much about wiring can i replace the front wiring harness thanks kimber