passenger door

[mnfootball08]

when i was changing oil i tried to put the car up on ramps, but as i was doing this the ramps shot under the car and got stuck. now when i open my passenger door it gets cuaght on the body of the car. does anyone know how i can fix this

[mnfootball08]

i dont think its nessasary for this problem but i have a 3.8 L v6 97 grandprix sn

[BNaylor]

Do you have a 2 door coupe or 4 door sedan?

Just where exactly is it getting hung up or binding. Unless some part of the unibody was damaged, door to body alignment must be done at the hinges.

[mnfootball08]

its a 4 door it is catching on the bottom front of the door how do i adjust that and is it easy

[BNaylor]

Originally Posted by mnfootball08

its a 4 door it is catching on the bottom front of the door how do i adjust that and is it easy

Are you sure the bottom of the door frame (body side) wasn't damaged in the mishap? How does the door alignment look otherwise. The air gaps between the front fender and to the rear passenger door? The top of door relative to the roof? Adjusting a door can be very tedious and a PITA of a job. Another area where you can adjust the door is at the latch/striker plate on the door frame. Check to see if it got loosened. Two Torx type bolts hold it on. One way to check this is whether the door is latching properly. Note that adjusting a door may not compensate for structural damage to the unibody. You may have to take it to a body shop and have them fix any damage. Good luck!