|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Let's get Technical! Discussion for hardcore in-depth motor heads! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
06-07-2006, 09:38 PM
|
|||
|
|||
|
Diagrams
Ok so I just got my B16A engine in last week and there are alot of stuff cut on the engine like hoses and wires.I am droping it into a 90 Crx and I need some help with the wires... the hoses i can deal with. I just need some diagrams on where things should go cause that would help me out alot and save me a bunch of time before I get that engine in and starting wondering where things need to be.
Thx For helping! Crx Guy P.S - I am going to do some searching on my own so don't think I am lazy 
|
|
#2
06-09-2006, 05:55 AM
|
|||
|
|||
|
Re: Diagrams
The Auto Reference Repair Center website access is available at some libraries. They have some wiring info in PDF format that can be printed.
|
|
#3
06-09-2006, 09:53 AM
|
|||
|
|||
|
Re: Diagrams
finding info on the most common crx b series swap is just too easy even if i didnt try.
http://www.phatwhippincrx.20m.com/custom.html http://www.automotiveforums.com/vbul...ight=b16a+swap
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
