|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
05-12-2006, 03:32 PM
|
||||
|
||||
|
Big Problem
i put new cv's in my 93 Delsol si and i have done this with a few cars before but now that i have put my cv's in the car wont move when i put it in gear. i have tried to figure out whats wrong but cant the cv's are seated the way they are suppost to be everything looks good as far as bearings go. anyone have any ideas on wut to do?
|
|
#2
05-13-2006, 10:55 PM
|
|||
|
|||
|
Re: Big Problem
you physically and visually made sure all splines from the 32mm hub bolt to the halfshaft splines in the the tranny are ALL the way in?
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
05-14-2006, 10:10 PM
|
||||
|
||||
|
Re: Big Problem
i fixed it this morning i thought i had them in as far as they could go but i guess i didnt my friends dad is a machanic and came over and had it done in like 3 seconds i felt dumb
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
