|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
05-11-2006, 11:40 AM
|
|||
|
|||
CV joint
that "pop pop pop" sound when i turn... thats a bad cv joint, right? how difficult is it to replace? should i do both sides at the same time, or is it okay to just do one? is there anything that i need to know before embarking on this job? keep in mind that i am pretty much mechanicallyNOT inclined. but i can read and follow instructions pretty well. i wanna do it myself because i had the same problem with my last probe and i just cant see paying 800 bux to get it done again...
|
|
#2
05-18-2006, 05:20 AM
|
|||
|
|||
|
Re: CV joint
Hi, I would really check out the price for a reman axle assy at autozone, It's a lot cheaper and less work than messing around with each individual cv joint. GOOD LUZCK . Clay..
|
|
#3
05-23-2006, 01:49 AM
|
||||
|
||||
|
Re: CV joint
theyre not hard to do just pay attention i did mine in about 2 hours taking my time,if u have the money might as well do both sides
__________________
Just because its a honda dosent make it fast ------------------------------------------- 96 gt-ze 2 1/4" magnaflo headers back,short ram intake ,msd,short throw shifter,eibach springs,fidenza fw,clutch masters stage 2,t3/t4 turbo install soon,poly engine mounts ------------------------------------------ www.probesnw.com www.probetalk.com www.mx6.com
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
