|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
FS: Tearstone Basic Kit
Calling this kit "basic" is an understatement. It is absolutley beautiful, and get compliments from even the most discriminating DSM guys. I have bills to pay and I might be forced to sell the kit. It was put on in October by Donny (AAI, GulfCoastTurbo) and has since seen about 8,000 miles. The kit also has the optional ceramic coating which I paid $225 to have done. I am looking to sell the kit as a whole, NOT Parting out. I am in the proccess of finding stock replacement parts....
![]() ![]() ![]() ![]() ![]() T3/T4 with billet wheel turbonetcis exhaust side turbonetics couplers all piping and hardware feedlines emanage (tuned) and harnesses pretty much the whole kit, everything you need -$3000 plus shipping I also have a manual boost controller from Donny's shop- $75 plus shipping I also have guages i can sell post up or Pm or my email- [email protected] or AIM- Dickswhip
__________________
www.Club3gse.com |
|
#2
|
|||
|
|||
|
Re: FS: Tearstone Basic Kit
Whats up with this forum nowadays? When I joined under my first s/n back in '04, this place was actually kind of busy.
Someone has to want this kit. The only waiting period is from when it leaves my doorstep and gets to yours......... not months on end.
__________________
www.Club3gse.com |
|
#3
|
||||
|
||||
|
Re: FS: Tearstone Basic Kit
I was kinda thinkin the same thing...kinda dead around here. Maybe it's cause the school year is ending and people are real busy with that; I know that's why I've been kinda away. Good luck with the kit (If it were a V6 kit I would seriously consider it man). What are you boostin with it/have you taken it to a strip to see what it'l do? What kinda power are you makin with it. Im just curious.
__________________
2000 Fed. Spec GT-"Lafawnduh" Mods: SPEC 2+ Clutch, Fidanza Flywheel, PowerStop Rotors, Red Stuff Pads, Stainless Brake Lines, B&M Short Shifter, Energy Suspension Shifter Bushings, Deyeme Firm Motor Mounts, KYB AGX shocks with Eibach Proline springs, Halo Projector Headlights with HID 12000K Conversion, TYC Carbon Tails, Kicker SS6.5 Component Front, SS MB8 Custom rear, Tsunami 2F Capacitor, ***New Stuff*** JVC KD-AV7010 In Dash DVD Player, Kicker L7 12" Woofer, Kenwood KAC-X10D Mono Amp |
|
#4
|
|||
|
|||
|
Re: FS: Tearstone Basic Kit
car put down [email protected]. keep in mind it is a sporty.
tune is conservative and set for 10psi. I turned it up to 14psi and ran a 14.0 with a 2.3 60'. I had a full tank of gas, and my sub in the car. Given that and the the fact that i have cheap tires (fuzion HRi's), i know the car would have gotten into the 13's without a problem. Its pretty nice to burn Z's and run with vette's in a 3G.
__________________
www.Club3gse.com |
|
#5
|
|||
|
|||
|
Re: FS: Tearstone Basic Kit
i would get it but im already svain to get the pro kit and have the engine rebuilt.
|
|
#6
|
|||
|
|||
|
Re: FS: Tearstone Basic Kit
i do want it but don't have the money.
__________________
My ride: 2002 ZX-6R CH-53E Want to get: 2008 6R or 10R Evo VIII or STi |
|
#7
|
|||
|
|||
|
Re: FS: Tearstone Basic Kit
Hurry up and save. Intrest is picking up.... mainly on the .org boards.
__________________
www.Club3gse.com |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|