|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Let's get Technical! Discussion for hardcore in-depth motor heads! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-07-2006, 12:16 PM
|
||||
|
||||
|
wiring for my swap
Ok im getting a guy to install my engine but he says I have to swap it over from dualpoint to multiport injection first, im getting the ecu and harnesses to go with the swap so y would I have to still do the extra wiring if I have all the stuff to make the new engine run? sorry may b a dumb question but Im not up on wiring
__________________
Finally getting my swap done, Thought I would be relieved and satisfied, now I just wanna spend money on other car parts, WHERE DOES THE MADNESS END!!!! 
|
|
#2
04-08-2006, 12:54 AM
|
|||
|
|||
|
Re: wiring for my swap
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
04-10-2006, 12:00 PM
|
||||
|
||||
|
Re: wiring for my swap
thank you
__________________
Finally getting my swap done, Thought I would be relieved and satisfied, now I just wanna spend money on other car parts, WHERE DOES THE MADNESS END!!!!
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
