|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
03-24-2006, 04:20 AM
|
|||
|
|||
|
RC Engineering Injectors in Stock 94 GSR Manifold...?
I bought some RC Engineering SL2-310cc Injectors for my 94 GSR project, on Ebay, and they don't seem to fit... They are slightly longer than stock (tip to tip), and they are too big for the stock grommets. I bought them like 3 years ago, they didn't come with grommets, other than the o-rings on the fuel rail side.
I found some RC injectors that claim they fit a 94 integra on another website, but they are SL9-310cc. So I'm not sure if these are the wrong injector model, or I just need a special grommet. I can't seem to find RC injector grommets sold anywhere... Grr!
__________________
94 Integra LS Engine is in the car! Installed parts GSR block/head, ARP head studs, eagle rods, Endyn pistons/rings, King bearings, REV stainless valves, Portlfow springs &Tit. retainers, BBK 70mm Throttle body, RC 310cc Injectors, Aerospeed plug wires, generic 2.75" CAI, Civic SI crank pulley, 130amp alternator, Hondata S300 in P72 ECU 01 GSR shocks/springs, 17" Enkei Zenkei's, Homemade Black ABS trunk floor Mods: Removed AC system, routed Coolant Outside Intake Mani 
|
|
#2
03-24-2006, 08:40 AM
|
|||
|
|||
|
Re: RC Engineering Injectors in Stock 94 GSR Manifold...?
try and call RC engineering and match part numbers with the one you have and the one that fits a '94
i have RC 750cc on my car but i have a AEM high-flow rail
__________________
 26 PSI anyone?
|
|
#3
03-24-2006, 01:12 PM
|
|||
|
|||
|
Re: RC Engineering Injectors in Stock 94 GSR Manifold...?
I emailed RC Engineering and they sent me an install sheet, and a number with which to order the proper lower seals(quick response time). They said the injector doesn't sit as deep as the stock injectors. $13.50 for 4 shipped priority mail, should be here around Wednesday.
They said some people manage to make the stock seals work, but I'd rather not mess with the depth the injector is inserted into the manifold, and the possibility of a vaccuum leak. Thanks for your help anyhow!
__________________
94 Integra LS Engine is in the car! Installed parts GSR block/head, ARP head studs, eagle rods, Endyn pistons/rings, King bearings, REV stainless valves, Portlfow springs &Tit. retainers, BBK 70mm Throttle body, RC 310cc Injectors, Aerospeed plug wires, generic 2.75" CAI, Civic SI crank pulley, 130amp alternator, Hondata S300 in P72 ECU 01 GSR shocks/springs, 17" Enkei Zenkei's, Homemade Black ABS trunk floor Mods: Removed AC system, routed Coolant Outside Intake Mani
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
