|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| How-To's and Walk-Through's Here's where we show you how it's done! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
03-10-2006, 11:13 PM
|
|||
|
|||
|
1990 Civic Distributor
My wife has just bought a 1990 Honda Civic and was told it needed a distributor. Would anyone like to shed some light on how these are installed?? Is it a tough job or not? I beleive it's a 1.6 engine...not totally sure till tomorrow....i know it mounts on the passenger side of the motor from I had seen. Thanks.
|
|
#2
03-11-2006, 08:01 PM
|
|||
|
|||
|
Re: 1990 Civic Distributor
remove 3 12mm bolts. unplug harness. pull out. installation is of reversal.
then do this http://www.c-speedracing.com/howto/timing/timing.php
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
03-15-2006, 07:50 PM
|
|||
|
|||
|
Re: 1990 Civic Distributor
Do those distributors go in only one way???? I know some cars can be 180 off but they will just backfire....you take them out and do it again.....
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
