-
Go Back   Automotive Forums Car Chat > Ford > Windstar
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 03-09-2006, 07:58 AM
96windstar 96windstar is offline
AF Newbie
 
Join Date: Mar 2006
Posts: 2
Thanks: 0
Thanked 0 Times in 0 Posts
96 windtar engine

I have a 96 ford windstar with the 3.8 engine with 132,000. When sitting at a stop with the vehicle in drive and the foot on the brake the engine will idle fine except every 10-15 seconds will have a slight hesitation or possible miss. It runs fine other than that, any ideas?

A little background, I had pulled the engine codes that were on for quite a while. P-0171-p0174. I fount the vacume leak and repaired it. Replaced the mass air sensor. had a rough idle and replaced the idle control sensor seems to be running good now except the small hesitation at idle.
Reply With Quote
  #2  
Old 03-09-2006, 11:05 AM
12Ounce 12Ounce is offline
AF Fanatic
 
Join Date: Sep 2004
Posts: 4,088
Thanks: 21
Thanked 152 Times in 148 Posts
Re: 96 windtar engine

Your brake booster make have a leak in it. Temporarily disconnect and plug the vacuum hose going to the booster for a test.

BEWARE: you will have no power assist brakes during this test!
Reply With Quote
  #3  
Old 03-09-2006, 09:04 PM
wiswind wiswind is offline
AF Moderator
 
Join Date: Sep 2004
Posts: 3,639
Thanks: 0
Thanked 116 Times in 92 Posts
Re: 96 windtar engine

Also, take note that the A/C compressor is STILL working in all settings except OFF, and VENT. I have had mine cycle at that rate, in cold weather.
In other words, it works (at least on my '96) even in HEAT only (floor outlets) in Wisconsin winter.
When the A/C compressor engages, it places a slight load on the engine, and you will notice a slight hesitation followed by a momentary slight increase in RPMS.
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Ford > Windstar


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 02:29 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts