Help Wid This Dumb Noise Prob!!!!!!

Team PHATBOYZ · #1 03-03-2006, 07:42 PM

Hey guys! OK heres the deal. Well i just got a new transmission and installed and only drove it to work and back and then this wierd sound just started. Like a loud GRINDin sound. The car can't even move anymore? It would go in gears but the sound would get louder. so basically u can't DRIvE THE CAR then i guess. lolz. But yea! So when i start up my car, i have to step and hold on to the clutch pedal to make the grindin sound stop. If i let go then somethin grinds? Is it my Tranny? or is it somethin else? N E 1 knos HOLLATCHABOY! (note: b18a swap)

clawhammer · #2 03-03-2006, 09:54 PM

Is there transmission fluid in the tranny?

FrodoGT · #3 03-03-2006, 10:08 PM

My transmission makes a little bit of noise all the time, but I'm sure its normal, just barely audible if you put your ear like right on it, its the internals always spinning...I would say your a little under lubricated..Or youve got a messed up bearing, thats just scraping itself round and round...

FuLL BLown STD · #4 03-03-2006, 11:33 PM

sounds like both of u guys got bad throw out bearings.. my throwout was making the grinding sound to but i never had my car lockout on me.

FrodoGT · #5 03-04-2006, 12:06 AM

Thats what I meant when I said bearing...But mines not grinding, just sounds like bearings turning....just sound.

Team PHATBOYZ · #6 03-04-2006, 10:14 PM

HAHAH thx guys butta i found out the prob. It was my freakin ACT clutch plate that was worned out. Like the middle where the tranny gear goes into. Yea the ACT clutch plate was all freakin worned out. So yea.. Wait do u guys think its the tranny that caused it?

FrodoGT · #7 03-05-2006, 01:22 AM

Hmmm, I have an ACT clutch *sneakes out the door with various wrenches and a hammer*....

Hybrid1990crx · #8 03-05-2006, 02:32 PM

Quote:

Originally Posted by FuLL BLown STD

sounds like both of u guys got bad throw out bearings.. my throwout was making the grinding sound to but i never had my car lockout on me.

is that right? so you think that when the clutch pressed the floor to make the noise stop that its the throw out bearing? Isn't that when the bearing is spinning, Dustin? So technically if it was the throwout bearing the noise should stop with the clutch pedal up and make the noise with the pedal pressed. Unless its a fulltime throwout bearing, which cable honda trannys arent.

FrodoGT · #9 03-05-2006, 06:44 PM

Smacked down! Eh everyones wrong sometimes... Couldn't hurt to check everything though...Hope for the best, plan for the worst.

FuLL BLown STD · #10 03-05-2006, 06:54 PM

Lick my balls Brian

yeah im never bothered when i stand corrected

Hybrid1990crx · #11 03-06-2006, 07:30 AM

don't worry dustin i still love your fat ass.

POST REPLY TO THIS THREAD