|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Off-Topic Talk about anything other than cars. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
03-03-2006, 06:26 PM
|
||||
|
||||
Not sure on this balance shaft removal kit
The kit i ordered looks like normal replacement bearings with the hole in them, is the object to cover the hole in the block for the oil? If so i just turn the bearings were the holes do not line up correct?
__________________
Current Cars 2006 Eclipse GT 6 speed MT (V6 3.8), mods so far- S Tech Springs, after market 18's, 2012 headlight Conversion, Greddy cat back exhaust, CAI, RRE Headers, Polyurethane Motor Mounts, NX Nitrous kit at 100 shot for now, RPM Window Switch, Triple Pod. 2003 Grand AM GT - official beater car for the winter lol ---------------------------------------------------- 95 TSI AWD [email protected] (T-25) Now fully Modded engine with 3,560 miles on it.SOLD 
|
|
#2
03-03-2006, 07:37 PM
|
||||
|
||||
|
Re: Not sure on this balance shaft removal kit
yes you just put the holes on the opposite side from being lined up
__________________
-1stGenRocks- 95 Tsi AWD: 6 bolt, DSMLink, 880's, ACT 2600, lightweight flywheel, AGX's, Dropzone springs, poly motor mounts and suspension bushings, 3 inch turboback, gus modded 1g BOV, hardpipes, drilled & slotted rotors, 17's plans: bastard 20g, water/meth injection NO FMIC
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
