|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-21-2006, 10:41 PM
|
|||
|
|||
|
lock-up solenoid
alright i bought a lockup solenoid for my 700-R4 tranny on my 88 cap. and i needed some step by step instructions on how to replace it and if i could get some pictures of the same tranny and all that.i tried to find site but i couldnt find them.
|
|
#2
02-21-2006, 11:52 PM
|
||||
|
||||
|
Re: lock-up solenoid
Go to Autozone and grab a Haynes GM Automatic Transmission book - it'll have detailed, step-by-step instructions.
It's not a hard job to do, though it can be messy (you have to pull the pan from the transmission). Get a filter and gasket set for it too - change the filter while you're in there (you have to pull it off, anyway). Just make sure you grab the reinforced o-ring seal for the filter tube out of the pump body - these like to lodge in the pump intake.
__________________
1988 9C1 - Modified LM1 @ 275HP/350TQ - TH700R4 - 3.08 8.5" Disc Rear - see it at http://www.silicon212.org/9c1! 2005 Crown Vic P71 - former AZ DPS - 4.6 liters of pure creamy slothness! 1967 El Camino L79/M20 old school asphalt raper Remember - a government that is strong enough to give you everything you need, is also strong enough to take everything you have.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
