|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-12-2006, 03:16 PM
|
||||
|
||||
Removing Rivets
im planning on replacing my passenger window in my blazer.
Whats the easiest way to remove those annoying rivets?
__________________
92 S10 Blazer Sport 4.3l Vortec V6 (W) 275,000 miles Jasper engine, Rebuilt tranny + rearend 04 Pontiac Grand Prix GT 43,000 miles 
|
|
#2
02-12-2006, 03:42 PM
|
||||
|
||||
|
Re: Removing Rivets
I'd imagine drilling them out, then use sheet metal screws to finish up the job.
__________________
2002 Chevy S-10 ZR2
Quote:
|
|
#3
02-12-2006, 06:39 PM
|
||||
|
||||
|
Re: Removing Rivets
If you're referring to the regulator: These rivets are aluminum and drill out very easily. Use a 1/4" drill in the center of each rivet. Once the head of the rivet is off, use a 1/8" punch to push the stem through. Use 1/4"x20x1/2" bolts, nuts & lock washers. If you're referring to the glass itself, use 1/4"x20 bolts & 1/4"x20 nylock nuts.
Last edited by old_master; 02-12-2006 at 08:24 PM.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
