|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
02-02-2006, 01:38 AM
|
||||
|
||||
|
Si front end conversion
ok i know this probably have been covered in past threads already but i tried searching for it but i couldn't find none.. but my question is when doin this do u really have to change your fenders, lights and hood just to fit the Si front bumper? this guy that works close to my job just did his and i was talkin to him and he told me that u have to do all that because the whole front is wider than the 96-98 fronts.. to me they look the same just the front bumpers changed but that could jus be me.. well thanks for any help
__________________
NicTasTic!  
|
|
#2
02-02-2006, 02:50 AM
|
|||
|
|||
|
Re: Si front end conversion
a question asked a million times over.
you need to change the whole front.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
