|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
01-24-2006, 01:06 PM
|
|||
|
|||
|
b16 wiring question
i know you probably see this question all the time.. but if i dont want to buy the wiring harness for $250 from hasport can anyone give me exact wiring instructions for a b16a1 into a 89 crx dx.. i understand theres a dual point fuel injection problem on the dx but two years ago there was a zc swapped into it so would that eliminate that problem?
|
|
#2
01-25-2006, 12:21 AM
|
|||
|
|||
|
Re: b16 wiring question
i have a writeup on my comp, what is your email. its a large file so i hope you are not on 56k :P
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
01-31-2006, 11:14 PM
|
|||
|
|||
|
Re: b16 wiring question
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
