|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| How-To's and Walk-Through's Here's where we show you how it's done! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
11-30-2005, 06:15 PM
|
|||
|
|||
|
wheel bearings
I have a 2000 Honda Prelude SH and need to change the rear left wheel bearing but i dont know how!!
|
|
#2
12-01-2005, 02:06 PM
|
|||
|
|||
|
Re: wheel bearings
remove 32mm nut. pull hub out. replace and tighten nut back on.
if you were doing the front, then, that is a whole different story.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
12-05-2005, 10:20 AM
|
||||
|
||||
|
Re: wheel bearings
the fronts are fun!!
__________________
2015 DGM STi - 2006 SGM STi - 1999 Built/boosted GSR
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
