|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
11-25-2005, 03:09 PM
|
|||
|
|||
4 wheel drive button
When I push the button on the 4 wheel level to switch into 4 wheel drive, the light doesn't go on, nor does the vehicle engage in four wheel drive. Is there a fuse to that opporation? Where is the fuse?
I stopped and put it in low (trabsfer case) and it still doesn't seem to be ion 4 wheel drive. Help! 
|
|
#2
11-26-2005, 01:14 AM
|
||||
|
||||
|
Give some details on your vehicle, year, engine, tranny,
On my 92 it has the A.D.D. and the switch that activates the light is in the front differential where a vacuum diaphragm locks the axel only when it is fully engaged will the light come on. I had the vacuum line disconnect at the differential that caused it not to engage. Most probable cause is a vacuum line came off the VSV valve on the fender in the engine compartment or the valve is faulty itself. 2003 F.S.M.: http://personal.utulsa.edu/~nathan-b...26addcontr.pdf Good Luck!
|
|
#3
11-26-2005, 09:31 AM
|
|||
|
|||
|
Re: 4 wheel drive button
It's an '97 4 Runner Limited with 4 wheel drive but no
A.D.D. I thought it was a fuse, manual said fuse was in the car. Checked all fuses in dask fuse boxes and none appear blown. I will check the vacuum hose , is it on the transfeer case or on top of the engine. Quote:
|
|
#5
11-30-2005, 07:42 PM
|
|||
|
|||
|
Re: Re: 4 wheel drive button
Quote:
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
