|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
11-18-2005, 08:19 PM
|
|||
|
|||
|
97 EX Hood Won't Open
The plastic on the end of the cable cracked off, as most do, but I have always used some needle nose to open it. Well, this morning it would not open. Pulled out about half to 3/4 of an inch but nothing. Any advice to get it open? Anyway to do it from the outside of the car? I am planning on replacing the cable but I need the hood open to do it. Should I just pull the shit out of the cable and hope it opens? I don't want to mess it up more than it already is.
Thanks in advance..... 
|
|
#2
11-18-2005, 08:25 PM
|
|||
|
|||
|
Re: 97 EX Hood Won't Open
get your hands behind the bumper and pull the cable.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
11-18-2005, 11:04 PM
|
|||
|
|||
|
Re: Re: 97 EX Hood Won't Open
Quote:
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
