|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
11-04-2005, 07:48 AM
|
|||
|
|||
2002 Blazer Window
I have a question on replacing the passenger side window on a 2002 blazer. Do I have to remove the entire window regulator just to replace the glass? It looks like the window is clamped into the track the wheels of the regulator slide on and I would have to drill out the rivits of the regulator just to replace the glass. Could anyone confirm. Thanks much!
|
|
#2
11-04-2005, 04:50 PM
|
||||
|
||||
|
Re: 2002 Blazer Window
No, simply lower the window about 2 inches, then remove the 2 10mm bolts holding the clamp to the window (these actually go through the base of the window) Lift the window and tilt it out at the same time... Make sure there is a track clip on each side of the window, if not, check your tracks and pull it out..
__________________
  95 s10 Blazer, EGR Mod, ZQ8 Steering box mod, 99 Center console shifter mod and more... See everything at www.pghconsulting.net/teal
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
