Cold air intake Fab question

[colinlesser]

ok i have a quick question, instead of buying a cold air intak ecant i just make one out of some tubing? and a k&N air filter?

[Thor06]

Thats what I am going to do. I'm sure everyone else on this forum will tell you to get a AEM or whatever but I seriously doubt that there will be that much difference between an AEM and a home made one. I am just going to buy some silicone couplers, a few of those clamp things, and some straight pipe and make my own.

[colinlesser]

i was going to use some flexible tubing for it so i could position move it arround

[colinlesser]

where can i get a silicone coupler? advanced auto?

[jakegday]

Originally Posted by colinlesser

where can i get a silicone coupler? advanced auto?

if your talking about one of those rubber type things that you use to connect your intake to your car, good luck finding one, when i tried to find one parts stores told me the only way i could get one was to buy an intake

[bh04]

Originally Posted by jakegday

if your talking about one of those rubber type things that you use to connect your intake to your car, good luck finding one, when i tried to find one parts stores told me the only way i could get one was to buy an intake

Thats a bunch of bull. You can get them at Menards. Well, thats where i've gotten them before. Or some hardware store should have them.

[colinlesser]

would making a dual cold air intake make a difference from a single?

[Thor06]

On a non forced induction car, I highly doubt it.

[colinlesser]

hey that intake you have "int the closet" wanna sell it? thats if it will fit a ecotech