|
|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
|
|||
|
|||
|
99 Contour SE's motor mount
My 99 contour' belt broke because 2 of the pulleys went bad. After the belt got replaced the car made a lound noise ( grurrr) when I stopped at the traffic light but it will be gone if I turn off my A/C. Someone told me it might be my A/C clutch is going to die. It seems like the car make noise when I put the car in reverse also. Open the hook and let my daughter put the car in drive mode the whole engine seems to lift up and down but not shaking. Does the engine mount is the problem? how about tranny mount and other mount??? How hard for me to change it myself. I dont have a whole lots of $$ to spent. Seems like $ sign every time I turn around and dont get raise as often as gas price jumps at the pump over night.
Thansk for all your hepls. |
|
#2
|
||||
|
||||
|
Re: 99 Contour SE's motor mount
4 cylinder?
My zetec does the same thing and I've been told the motor mounts are fine.
__________________
-Josh- 96' Integra GSR / ITR cams/valvetrain. Skunk2 IM, Greddy evo2, AEM CAI, RMF Header, Megan testpipe, Hasport mounts, Eibach coilovers, Beaks tie bar, Megan H brace, Rota Attacks, F/R strut bar, Kirk 6 point cage, Bride Cugas, Takata 4 Point, ITR Steering wheel 98' SVT Contour, 3L Port-Matched swap with SVT cams/full bolt ons; 224fwhp. 01' Chevy Blazer, DD. |
|
![]() |
POST REPLY TO THIS THREAD |
![]() |
|
|