1996 Blazer starting problems

Liberte · #1 09-06-2005, 10:04 AM

I have a 1996 s-10 Blazer with 4.3L CSFI vortex engine. The engine dies or runs real rough when first starting. Once it starts it runs great on the highway sometimes at stop signs it hesitates a little but not all the time. Trouble codes come up as P0102 (Mass Air Flow) and P0340 (camshaft sensor). I rep[aced the mass air flow sensor and it ran fine for 2 weeks the starting the same thing again. Then replaced camshaft sensor but didn't make any difference. I am out of ideas on where else to look

BlazerLT · #2 09-07-2005, 02:21 AM

Is the check engine light on again?

Liberte · #3 09-07-2005, 09:41 AM

I think the check engine light is burnt out. It used to come on but doesn't now.

BlazerLT · #4 09-07-2005, 11:27 AM

Does it come on when you start the engine?

Turn the ignition forward to the first position and look for it.

Liberte · #5 09-08-2005, 10:22 AM

The engine light does not come on when trying to start. It was on for quite awhile before trying to fix. I had the codes read yesterday and the erased. Started car and read codes again. Only codes P0102 and P0340 show up

BlazerLT · #6 09-08-2005, 11:16 AM

Quote:

Originally Posted by Liberte

The engine light does not come on when trying to start. It was on for quite awhile before trying to fix. I had the codes read yesterday and the erased. Started car and read codes again. Only codes P0102 and P0340 show up

I would have it hooked up to a scantool and have the sensors monitored.

POST REPLY TO THIS THREAD