-
Grand Future Air Dried Fresh Beef Dog Food
Air Dried Dog Food | Fresh Beef

Carnivore Diet for Dogs

Go Back   Automotive Forums Car Chat > BMW > 3 Series
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 09-04-2005, 08:52 PM
dick01 dick01 is offline
AF Newbie
 
Join Date: Sep 2005
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
1985 318i engine cuts out - need help

When driving for about 5-10 minutes the engine just cuts out like someone turned off the fuel. Most of the time if you wait 5-10 minutes the car will restart and run for anywhere from 2-10 minutes before doing this again.

I have checked the fuel pumps and believe them to be ok because I have fuel pessure (checked with a good guage). I also have good spark at this time too, but no signal to turn on the injectors.

I have the Bently book and have been through most everything in it with no improvement.

The one thing I have noticed is that if I pull the connector off the air flow switch unit the car will start, but runs very rough. When putting this connector back on the engine rpm increases for a few seconds and then dies and is back to the same state as before.

I am getting so frustrated with this as it's not like I have not tried to check as much as I can, but with parts costing so much I can't just start putting on new parts.

Please help!
Dick
Reply With Quote
  #2  
Old 07-22-2007, 09:06 PM
joey1966 joey1966 is offline
AF Newbie
 
Join Date: Jul 2007
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 1985 318i engine cuts out - need help

Quote:
Originally Posted by dick01
When driving for about 5-10 minutes the engine just cuts out like someone turned off the fuel. Most of the time if you wait 5-10 minutes the car will restart and run for anywhere from 2-10 minutes before doing this again.

I have checked the fuel pumps and believe them to be ok because I have fuel pessure (checked with a good guage). I also have good spark at this time too, but no signal to turn on the injectors.

I have the Bently book and have been through most everything in it with no improvement.

The one thing I have noticed is that if I pull the connector off the air flow switch unit the car will start, but runs very rough. When putting this connector back on the engine rpm increases for a few seconds and then dies and is back to the same state as before.

I am getting so frustrated with this as it's not like I have not tried to check as much as I can, but with parts costing so much I can't just start putting on new parts.

Please help!
Dick





I am having the same problem ==did you ever figure yours out= please help!
Reply With Quote
  #3  
Old 07-23-2007, 01:54 PM
meharris meharris is offline
AF Newbie
 
Join Date: Nov 2001
Posts: 11
Thanks: 0
Thanked 0 Times in 0 Posts
Send a message via MSN to meharris
Re: 1985 318i engine cuts out - need help

I am not familiar with the e30 318, however, my 97 318i did the same thing. It was the camshaft position sensor. Check the mass air flow sensor and if your car has one, the camshaft position sensor. I've also heard that the knock sensor will cause the same symptoms.

MEH
Reply With Quote
  #4  
Old 01-21-2008, 10:46 AM
Woodyeofalb Woodyeofalb is offline
AF Newbie
 
Join Date: Jan 2008
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Re: 1985 318i engine cuts out - need help

There's a control unit on the firewall just in front of driver; I replaced after this problem of sudden cut-off.
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > BMW > 3 Series


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 03:14 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts