|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-18-2005, 08:25 PM
|
||||
|
||||
|
removing the head
ok i guess this sounds like a stupid question but i was hoping that someone could explain to me step by step on how to remove the head on my car.im taking it off to get a valve job and a pnp. or maybe theres a web site that could help me here . well any help is appreciated
|
|
#2
08-19-2005, 12:47 PM
|
|||
|
|||
|
Re: removing the head
valve cover off. cams out. exhaust mani out. sensors and hoses off. IM support bracket off (leaveing IM in makes it easier for me). head bolts off.
thats basically it.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
08-19-2005, 12:54 PM
|
||||
|
||||
|
Re: removing the head
The head bolts should be taken off in a certain pattern, im not sure in which pattern for the zc im assuming? ide suggest getting a manual to help you.
__________________
2002 Acura TL Type S 1991 Honda Crx Si
|
|
#4
08-20-2005, 06:10 AM
|
|||
|
|||
|
ezst way get a manual bout 12$ at any autoparts store
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
