|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| How-To's and Walk-Through's Here's where we show you how it's done! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
08-03-2005, 11:12 AM
|
|||
|
|||
|
Ignition Fuse Keeps Blowing!!!!!
Alrighty, I've got another problem!!!!! So all I did was change my valve cover and now I keep blowing my Ignition Fuse.
Can anyone tell me why this keeps happening???? Thanks 
|
|
#2
08-03-2005, 01:07 PM
|
|||
|
|||
|
Re: Ignition Fuse Keeps Blowing!!!!!
all grounds are where they need to be?
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
08-03-2005, 01:12 PM
|
|||
|
|||
|
As far as I know. There was only one ground and it happened to be attached to the Valve Cover. When I installed the new Valve Cover I attached the ground to the same exact spot that the ground was attached to the old Valve Cover.
I don't know what else it could be. There isn't anything electrical around there. I was thinking that maybe a wire was touching somewhere that it wasn't supposed to be, but I haven't messed with anything electrical except the Negative Battery Cable and that Ground. I'm so lost......lolololol.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
