|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Interior | Audio | Security Tech forum to assist in Honda/Acura Interior, Audio and Security. |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
07-24-2005, 08:36 PM
|
||||
|
||||
|
resistance
if you have a two-channel amp that when bridged puts out 800 watts at 4 ohms, is it possible for the amp to put out 1600 watts then at two ohms?
also, is it possible to only wire one of the voice coils on a dual voice coil sub without the sub blowing? dont make fun of me b/c im retarded
__________________
Silly ricer, wings are for planes 
|
|
#2
07-24-2005, 10:48 PM
|
|||
|
|||
|
Re: resistance
you have to run both voice coils of the sub and technically yes, your amp would produce said power but you have to make sure that it will be stable at that ohm load. good luck
__________________
97 Prelude *DC Sports 4-2-1 Header *AEM Intake *RSR Exmag Catback Exhaust *DC Sports Short Shift Adaptor *Two Way Alarm *Piaa Super White Headlights *Momo Shift Knob *Black Suede Headliner *All Black Interior (changed from tan) *Alpine CDA-9835 Head unit *JL Audio 3 way components powered by Alpine MRD-345 *1 12" Eclipse Titanium powered by Alpine MRD-1005 *Dynamat Extreme everywhere and Monster Wiring throughout *Alpine KCA-420i IPOD Interface *Skunk2 OBD I Race Computer
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
