-
Go Back   Automotive Forums Car Chat > Chevrolet > Lumina
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 06-02-2005, 09:15 AM
EAGLESFAN EAGLESFAN is offline
AF Newbie
 
Join Date: Aug 2004
Posts: 37
Thanks: 0
Thanked 0 Times in 0 Posts
Angry '93 lumina overheating

I don't think my radiator fans work b/c I was stuck in traffic yesterday and my car began to overheat, and i could smell radiator fluid burning. I noticed my fans never came on. I could hear the radiator fluid was boiling. What might be the problem with the fans? how do i check the relay? I know the motors are okay, I jumper'd them to the battery. Plan of action? Thanks
Reply With Quote
  #2  
Old 06-02-2005, 10:40 AM
Manny_boy's Avatar
Manny_boy Manny_boy is offline
AF Regular
 
Join Date: Jun 2004
Posts: 377
Thanks: 0
Thanked 2 Times in 2 Posts
Re: '93 lumina overheating

Your coolant temperature sensor may be heading south. What engine do you have?
Reply With Quote
  #3  
Old 06-02-2005, 03:42 PM
EAGLESFAN EAGLESFAN is offline
AF Newbie
Thread starter
 
Join Date: Aug 2004
Posts: 37
Thanks: 0
Thanked 0 Times in 0 Posts
3.1 liter. I recently performed a total back flush on the cooling system and refilled 50/50 water-coolant. Also, my car doesn't overhead while moving, only when stuck in traffic or idle. Another concern is that my Idiot light doesn't come on, now that sounds like a sensor to me. Just don't know where that is. I'll look it up in my Chilton's book this afternoon. From what I've read, there are 2 sensors, idiot light and water senor. Do they both control the fan?
Reply With Quote
  #4  
Old 06-02-2005, 08:44 PM
Manny_boy's Avatar
Manny_boy Manny_boy is offline
AF Regular
 
Join Date: Jun 2004
Posts: 377
Thanks: 0
Thanked 2 Times in 2 Posts
Re: '93 lumina overheating

Right, there are two sensors. Nope, the one for the dash light is only for the dash light, and only has one wire. the one that tells your ecm how hot your car is has two wires (or three)?


I just thought of something... you mentioned you just performed a flush n fill. Did you bleed the air from your coolant system?


Also, enter diagnostic mode (paper clip trick) and if your fans turn on (at least one), you'll know for sure its not your relays or the wiring from the ecm.
Reply With Quote
  #5  
Old 06-02-2005, 08:49 PM
jeffcoslacker's Avatar
jeffcoslacker jeffcoslacker is offline
Lactose the Intolerant
 
Join Date: Aug 2004
Posts: 6,410
Thanks: 4
Thanked 52 Times in 51 Posts
Re: '93 lumina overheating

See if they turn on when the A/C is on. That should start them regardless of sensor input. If they don't, or just the aux fan comes on, try a new relay. Relays are easy and cheap, and common to fail. If the aux cooling fan runs with the a/c on, but the primary doesn't, you can swap the relays and get your primary working until you get a new relay. Just don't use the a/c if you run it like that.

The primary will only run when temp is about 2/3 up normal temp range, but shouldn't allow it to start boiling at idle.
__________________
You made three mistakes. First, you took the job. Second, you came light. A four man crew for me? F**king insulting. But the worst mistake you made...

...empty gun rack.
Reply With Quote
  #6  
Old 06-02-2005, 08:52 PM
jeffcoslacker's Avatar
jeffcoslacker jeffcoslacker is offline
Lactose the Intolerant
 
Join Date: Aug 2004
Posts: 6,410
Thanks: 4
Thanked 52 Times in 51 Posts
Re: Re: '93 lumina overheating

Quote:
Originally Posted by Manny_boy

I just thought of something... you mentioned you just performed a flush n fill. Did you bleed the air from your coolant system?
Good point. That'll fool the sensor sometimes, too. Can't sense air pocket temp.
__________________
You made three mistakes. First, you took the job. Second, you came light. A four man crew for me? F**king insulting. But the worst mistake you made...

...empty gun rack.
Reply With Quote
  #7  
Old 06-03-2005, 09:36 AM
EAGLESFAN EAGLESFAN is offline
AF Newbie
Thread starter
 
Join Date: Aug 2004
Posts: 37
Thanks: 0
Thanked 0 Times in 0 Posts
Where can i find the coolant temp sensor on the 3.1 liter engine?
Reply With Quote
  #8  
Old 06-03-2005, 12:28 PM
EAGLESFAN EAGLESFAN is offline
AF Newbie
Thread starter
 
Join Date: Aug 2004
Posts: 37
Thanks: 0
Thanked 0 Times in 0 Posts
Driver side fan came on when A/C was turned on, switched relays, same fan came on with A/C. Checked OBD codes and showed nothing BUT both fans ran during diagnostic. I'm guessing now it's the coolant temp sensor but the book does a poor job of telling me where that is. (adjacent to EGR pipe, but where is that?) Thanks
Reply With Quote
  #9  
Old 06-03-2005, 04:46 PM
jeffcoslacker's Avatar
jeffcoslacker jeffcoslacker is offline
Lactose the Intolerant
 
Join Date: Aug 2004
Posts: 6,410
Thanks: 4
Thanked 52 Times in 51 Posts
Re: '93 lumina overheating

COOLANT TEMPERATURE SENSOR


On your 1993 CHEVROLET LUMINA-SEDAN/COUPE, the COOLANT TEMPERATURE SENSOR is:




UNDER HOOD, DRIVER SIDE, REAR ENGINE AREA, MOUNTED ON REAR OF INTAKE MANIFOLD
__________________
You made three mistakes. First, you took the job. Second, you came light. A four man crew for me? F**king insulting. But the worst mistake you made...

...empty gun rack.
Reply With Quote
  #10  
Old 06-05-2005, 02:18 PM
EAGLESFAN EAGLESFAN is offline
AF Newbie
Thread starter
 
Join Date: Aug 2004
Posts: 37
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Re: '93 lumina overheating

Quote:
Originally Posted by jeffcoslacker
COOLANT TEMPERATURE SENSOR


On your 1993 CHEVROLET LUMINA-SEDAN/COUPE, the COOLANT TEMPERATURE SENSOR is:




UNDER HOOD, DRIVER SIDE, REAR ENGINE AREA, MOUNTED ON REAR OF INTAKE MANIFOLD

Damn, what a bitch to get to.
Reply With Quote
  #11  
Old 06-05-2005, 05:06 PM
EAGLESFAN EAGLESFAN is offline
AF Newbie
Thread starter
 
Join Date: Aug 2004
Posts: 37
Thanks: 0
Thanked 0 Times in 0 Posts
Okay, so I found the temperature sending unit (1 wire) driver side rear engine. But where is the temperature SENSOR located (2 wires). The book doesn't say. I believe it's the SENSOR that controls when the fan comes one at 195 degrees farenheit. I already baught the sensor but can someone help me locate it? Thank you.
Reply With Quote
  #12  
Old 06-28-2005, 10:08 PM
russell mceacharn russell mceacharn is offline
AF Newbie
 
Join Date: Jun 2005
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Re: '93 lumina overheating

I'm also looking for the temp sensor my temperature gets up to the half way mark and the cooling fan does'nt come on, I think half way is 210 degrees I'm not gonna let it get any hotter since I just got through doing a head gasket job which was no fun. I checked my 2 fan relays with a fused wire from the battery positive and ground they clicked and continuity was good, the coil and contact terminal numbers are on the relay,might save buying a new relay. also unplugged fans and applied battery power fans were good.
The guy at the auto parts store told me there are two temp. sensors ,one by the thermostat, which is easily found ,three wire, and the one he sold me a two wire, the one by the thermostat is for the gage? Ithink and still looking for the other. Oh by the way both fans run when the ac is on drivers side stays on and the other runs intermitently. The repair manual gives testing info for the sensor by the thermostat, but does not mention another, if I find it I'll let you know. 96 lumina
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Chevrolet > Lumina


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 06:07 AM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts