|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
05-19-2005, 07:02 PM
|
||||
|
||||
Cam idea's?
I was thinking of putting ODX stage 1 cams in my b16A with JG engine Dynamic dual springs and retainers. But the intake cam is just under a half inch lift, do you think the stock lost motion assembly will do or should I think to invest in a ITR lost motion assembly? Also is there really any thing else I should think about for reving 10'000rpm? I've already balanced the whole drivetrain.
__________________
95 JDM B16A Hatch DX  Stage 2 Zex Cams comp cams 913 springs and retainers professional products intake mani 68mm throttle body ZR racing header Handata s200 Password JDM intake 
|
|
#2
05-20-2005, 02:53 AM
|
|||
|
|||
|
If you're trying to make power above 8000-9000rpm you need a lot better than a stage 1 anything. You must port the head to move air at that speed, have a very high compression, sleeve the block because the open deck will die soon, ignition, you need one that can handle moving and firing that fast.
__________________
 
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
