|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-29-2005, 10:22 PM
|
|||
|
|||
help w/b18 swap
i searched and searched for info on this subject but i cannot find it, but i am doing a B18b1 swap in my 91 crx hf and i got the integra axles but the part that is supposed to go into the wheel it is to big and i am not to sure what to do i also bought motor mounts off of ebay and the guy said it is good for any b series motor but they don't seem like they are even close of fitting. whoever helped me out thank you a lot!!!
|
|
#2
04-30-2005, 02:30 AM
|
|||
|
|||
|
Re: help w/b18 swap
do you have a hydro or cable trans ? the drivers side mount needs to be from a 90-93 teg for it too fit, same with the rear mount if its a cable trans. hydro conversion if its a hydro trans
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
