|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-23-2005, 05:34 PM
|
|||
|
|||
|
doing my swap tomarrow
ok so im was going to do it today but its raining so tomarrow im doing my B16 crx swap. i have a couple questioins.first on the tranny there is the speedo cable and right next to it theres two hoses...wondering what they are cruise? should i cap them off and how....also wondering if any one had a good pic of where the vacuum lines go ive seen diagrams but there too confusing for me lol thanks
|
|
#2
04-24-2005, 01:17 AM
|
|||
|
|||
|
Re: doing my swap tomarrow
what is your email? ill send you the diagrams.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
#3
04-24-2005, 08:17 PM
|
|||
|
|||
|
nevermind the engine is in and the vac lines are all set....an old buddy of mine stopped by to help he has a b16 crx and he just capped off the hoses and we looked at his vac lines to figure out mine but thanks any ways
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
