|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
04-21-2005, 06:01 PM
|
||||
|
||||
|
Where do i add trans fluid in b16
hey real quick was gonna add some trans fluid and i wasn't 100% sure where to add it, think i got it, but i want to check. Posted a pic of where i think it goes
|
|
#2
04-21-2005, 06:04 PM
|
||||
|
||||
|
|
|
#3
04-25-2005, 01:45 PM
|
||||
|
||||
|
Re: Where do i add trans fluid in b16
what you have in the picture is a transmission housing bolt. lift up your car and look under at the transmission housing. there are 2 bolts. 1 to drain and 1 to fill. let me try to find a pic to show you.
__________________
88 Honda CRX Si - B16 90 Honda CRX Si - B20VTEC
|
|
#4
04-25-2005, 01:50 PM
|
|||
|
|||
|
Re: Where do i add trans fluid in b16
On my car you use a half inch racthet without a socket to undo the transmission plug. In your picture, that is a bolt that connects the bellhousing to engine, not a good idea to take it off, if you did read the specs and torque it back in(prolly 22-36 lbs of torque). The fill plug will most likely be towards the front of the car on the side of the transmission, the plug on the bottom is the drain plug.
__________________
94' Nissan Altima SE K&N High Flow Air Filter Greddy St Exhaust OBX Header Short Throw Shifter Extreme Performance Clutch 68' AMC Abassador Chevy 350 TH 350 Tranny Headers Dual Exhaust 1999 Suzuki GSX-R 600 Yellow/Black Yoshimura Exhaust http://members.cardomain.com/wonword
|
|
#5
04-25-2005, 01:51 PM
|
||||
|
||||
 this image is small and confusing but i believe from this pic that #18 and #12 are the bolts.
__________________
88 Honda CRX Si - B16 90 Honda CRX Si - B20VTEC
|
|
#6
04-25-2005, 10:07 PM
|
|||
|
|||
|
Re: Where do i add trans fluid in b16
or you can fill it through the vent shaft. #5.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
