need the blessing

[EOD AIRFORCE]

Hey guys. Over the past 2 months I've been researching what I was gonna do with my 79Z. It appears I've come to the point were I walk the walk, but I wanted a final blessing on the setup I'm gonna do. Wanted it to still be a daily driver, even if I was pushin it a bit.

These were the vortec heads kit from scoggin-dickey I intend on buying.
It comes ready to bolt on, no maching required.It also comes with the Performer intake.
http://www.sdpc2000.com/catalog/2172...mer-Intake.htm

For camshaft I was looking at the xe274. Don't know much about cams, but it kept being suggested for the vortec heads.

And a Hughes 2500 stall converter.
As for a carburetor I was looking at the EDL-1406 600cfm. or the AVS series.
What do you guys think? Any suggestions on this setup or do you guys forsee any problems i might run into. thanks for the help.

[wrightz28]

my 2 cents:

check everything over before you install it. even the head's deck regardless.

oh, probably should have put this in the performance forum too?

[KaotiKCamaro5]

eh.. as far as putting this in the performance section... its not a big deal, there are likely to be more views and replies if its kept on the front page anyway.

*as far as the mods go, just make sure you really do your homework on the matter.. i too dont know much about camshafts or heads, but before i would install these items on my car i would make sure i consulted someone who did know, to make sure i got the right parts and setup

[lickem]

isnt that what hes doing?

[KaotiKCamaro5]

i more or less meant at a local shop.. not over the computer...