|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| Engineering/ Technical Ask technical questions about cars. Do you know how a car engine works? |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
03-29-2002, 06:18 PM
|
|||
|
|||
|
Need some help with a ZC problem!
Hi all! I have a problem that I hope someone can help me with. I swapped a ZC DOHC motor into my 91 CRX si yesterday. When everything was finished, I tried to start the motor. It will turn over, but wont start. I checked, and I have fuel, but no spark. I have voltage at the connection at the distributor, am pretty confident my wiring on the distributor is correct. I spliced in the integra connector, matched up wire color codes, and sent the two blue wires to the crank sensor. I am at a total loss right now. Any help? Thanks much for your time!!
|
|
#2
03-29-2002, 10:31 PM
|
||||
|
||||
|
Re: Need some help with a ZC problem!
Quote:
|
|
#3
03-30-2002, 12:53 PM
|
||||
|
||||
|
can you hear the starter winding???? because when we did my ZC in my old rex we just threw everything back in really quick and forgot the ground on the starter and that fucked everything up.
__________________
formerly "riceboi" back at ph 1990 Crx Si ..b16a1 ...i/h/e ...PYR Racing head..ctr pistons .. ...flywheel ...stage 2 clutch ...3.5 drop on Ground Controls ...Koni adj's all around ... ...mugen kit ...sloppy yellow paint job ...apex'i vafc ...gsr brakes ...gsr seats ...autometer a/f gauge ...and more crap that nobody cares about
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
