-
Grand Future Air Dried Fresh Beef Dog Food
Air Dried Dog Food | Fresh Beef

Carnivore Diet for Dogs

Go Back   Automotive Forums Car Chat > Saturn > SC/SL/SW
Register FAQ Community
Reply Show Printable Version Show Printable Version | Subscription Subscribe to this Thread
 
Thread Tools
  #1  
Old 03-22-2005, 01:15 PM
KPot2004 KPot2004 is offline
AF Enthusiast
 
Join Date: Jun 2004
Posts: 462
Thanks: 0
Thanked 0 Times in 0 Posts
Trouble Code 11

Code 11 means tranaxle codes present how do i know whta code it is??

thanks
Reply With Quote
  #2  
Old 03-22-2005, 11:57 PM
mysatilac's Avatar
mysatilac mysatilac is offline
AF Enthusiast
 
Join Date: Dec 2004
Posts: 739
Thanks: 0
Thanked 0 Times in 0 Posts
What symptoms have you been showing, in addition to check engine light?
i.e. studdering, hard shifts, etc.

Is it a manual of an auto?

I dont know of any easy tranny checks, but I'm no tranny guru. List as much info. as you can, it will help you get an accurate response.
__________________
It's beautifully destructive isn't it,
'97 Maroon SL1- Bored Throttle Body, Knife Edged Throttle Plate, Short Ram Intake 3" Cone Filter, Flip Flop Trunk, Red Enameled Engine, Interior & Exterior Painting Mods, 4" Burnt Tip Muffler, DRLs ON A SWITCH!, "Rims", Seat Covers, And A Stereo System Thats Too Good!, Other various mods and detailing...
Reply With Quote
  #3  
Old 03-23-2005, 01:17 AM
sierrap615 sierrap615 is offline
Master Tech Wanna-be
 
Join Date: Jul 2003
Posts: 2,728
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Trouble Code 11

code list - http://www.differentracing.com/tech_...ttc_chart.html

the codes will blink on the "SHIFT TO D2" or coolant light, depending on year.

transaxle codes are for auto trans only
Reply With Quote
  #4  
Old 03-23-2005, 10:28 AM
KPot2004 KPot2004 is offline
AF Enthusiast
Thread starter
 
Join Date: Jun 2004
Posts: 462
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Trouble Code 11

well the tranny is not shifting and it will get up to however many rpm's and not shift sometimes if i back off and try again it will shift, sometimes it wont. I am wondering if this could be in any way related to the egr being bad, becasue I can drive for a half hr and the tranny will shift fine, no problems at all but then as soon as the ses light comes on it starts acting up, and the 2 codes it storing are code 32-egr and code 11-transaxle codes

if its not related i guess they just both decided to go out at exactly the same time
Reply With Quote
  #5  
Old 03-23-2005, 12:50 PM
mysatilac's Avatar
mysatilac mysatilac is offline
AF Enthusiast
 
Join Date: Dec 2004
Posts: 739
Thanks: 0
Thanked 0 Times in 0 Posts
From what I'm seeing, it seems that your throttle valve cable is out of normal adjustment, it will prevent shifting at the correct times and would explain why if you let off and try it again it may shift for you.

This is most likely your problem, but...

Check/ clean your egr, if its unrelated you will have to deal with it later anyway, and its not hard to test and clean.
Repost if you need help with these procedures
__________________
It's beautifully destructive isn't it,
'97 Maroon SL1- Bored Throttle Body, Knife Edged Throttle Plate, Short Ram Intake 3" Cone Filter, Flip Flop Trunk, Red Enameled Engine, Interior & Exterior Painting Mods, 4" Burnt Tip Muffler, DRLs ON A SWITCH!, "Rims", Seat Covers, And A Stereo System Thats Too Good!, Other various mods and detailing...
Reply With Quote
  #6  
Old 03-23-2005, 09:32 PM
KPot2004 KPot2004 is offline
AF Enthusiast
Thread starter
 
Join Date: Jun 2004
Posts: 462
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Trouble Code 11

ok well i did the tranny fluid and filter and drove it around, now the tranny is getting code 42, vehicle speed sensor, could this be casuing my tranny problems???
Reply With Quote
  #7  
Old 03-23-2005, 10:43 PM
mysatilac's Avatar
mysatilac mysatilac is offline
AF Enthusiast
 
Join Date: Dec 2004
Posts: 739
Thanks: 0
Thanked 0 Times in 0 Posts
The check for the VSS is to unplug it (it is in the differential part of the trans.) and check to see if the PCM is sending it +10DCV, if it is not getting this voltage, the problem is your PCM.
I don't know of another test except replace the sensor, Might try a junk yard as it will be less expensive.

Yes, it is also responsible for telling the PCM when to have the tranny shift. And controls the fuel delivery system, which could throw an EGR code.
So there is a good chance this is your only problem
__________________
It's beautifully destructive isn't it,
'97 Maroon SL1- Bored Throttle Body, Knife Edged Throttle Plate, Short Ram Intake 3" Cone Filter, Flip Flop Trunk, Red Enameled Engine, Interior & Exterior Painting Mods, 4" Burnt Tip Muffler, DRLs ON A SWITCH!, "Rims", Seat Covers, And A Stereo System Thats Too Good!, Other various mods and detailing...
Reply With Quote
  #8  
Old 03-23-2005, 11:31 PM
sierrap615 sierrap615 is offline
Master Tech Wanna-be
 
Join Date: Jul 2003
Posts: 2,728
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Trouble Code 11

have you read the transaxle codes yet?

the VSS plays a HUGE part of the shift timing. its not going to shift into anything but 1st when stoped, and its not going to down shift when you are going 95 MPH. there are some codes that will put the car into a "limp home" mode. or in other words it will go into a default mode that will allow the car to remain driveable with minimizing any chance of damage. so you can drive to a repair shop instead of geting towed in. for example, it the computer sences a problem with the transmission, it will not allow the trans to shift or lock-up the TTC. it will stay ether in 2nd or 3rd (depending on make/model) this way you can drive with just one gear, you can't drive great, but you can drive.
Reply With Quote
  #9  
Old 04-22-2005, 10:15 PM
Meganski25 Meganski25 is offline
AF Newbie
 
Join Date: Apr 2005
Posts: 7
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Trouble Code 11

my car has the same problem...sucks doesnt it?
Reply With Quote
  #10  
Old 04-24-2005, 10:23 AM
peppermrj's Avatar
peppermrj peppermrj is offline
AF Regular
 
Join Date: Mar 2005
Posts: 466
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Trouble Code 11

Quote:
Originally Posted by mysatilac
From what I'm seeing, it seems that your throttle valve cable is out of normal adjustment, it will prevent shifting at the correct times and would explain why if you let off and try it again it may shift for you.

This is most likely your problem, but...

Check/ clean your egr, if its unrelated you will have to deal with it later anyway, and its not hard to test and clean.
Repost if you need help with these procedures
Mysatilac the auto's used in the saturns are more like manual trans. with electric shifting. No TV cable like conventional automatics. Would like to get into one to check it out but hopefully not my daughter's.

Kpot2004,
Sierrap615 asked.
Quote:
have you read the transaxle codes yet?
Well?
Reply With Quote
  #11  
Old 04-24-2005, 08:31 PM
mysatilac's Avatar
mysatilac mysatilac is offline
AF Enthusiast
 
Join Date: Dec 2004
Posts: 739
Thanks: 0
Thanked 0 Times in 0 Posts
Re: Re: Trouble Code 11

Quote:
Originally Posted by peppermrj
Mysatilac the auto's used in the saturns are more like manual trans. with electric shifting. No TV cable like conventional automatics. Would like to get into one to check it out but hopefully not my daughter's.
I haven't had to tear into one either (I hope its not your daughters either),
That suggestion was straight from a generic saturn diagnostic manual,
Thanks for the info, I won't soon forget,
__________________
It's beautifully destructive isn't it,
'97 Maroon SL1- Bored Throttle Body, Knife Edged Throttle Plate, Short Ram Intake 3" Cone Filter, Flip Flop Trunk, Red Enameled Engine, Interior & Exterior Painting Mods, 4" Burnt Tip Muffler, DRLs ON A SWITCH!, "Rims", Seat Covers, And A Stereo System Thats Too Good!, Other various mods and detailing...
Reply With Quote
 
Reply

POST REPLY TO THIS THREAD

Go Back   Automotive Forums Car Chat > Saturn > SC/SL/SW


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 04:53 PM.

Community Participation Guidelines | How to use your User Control Panel

Powered by: vBulletin | Copyright Jelsoft Enterprises Ltd.
 
 
no new posts