|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
03-09-2005, 04:10 PM
|
||||
|
||||
|
What did you use for a CAI?
I am surious, what have any of you used to make a cold air intake for a 3.0 24v duratec? I looked at the short ram intake that for sale out there, from like http://www.draxas.com/ but I am not sure how well it would work, since it would still draw air in from the hot engine bay.
any suggestions? ~Thomas
__________________
"Who are we to judge those, when we ourselves are afraid to be judged." 
|
|
#2
03-09-2005, 07:01 PM
|
||||
|
||||
|
Re: What did you use for a CAI?
its pretty hard to do a true cold air intake on a taurus, especially a duratec since there's so little room and because of the battery. No matter how much the intake companies build it up, the difference between a short ram and a cold air intake is negligible.
__________________
Dr. Disque - Current cars: 2008 BMW 135i M-Sport 2011 Mazda2 Touring Past cars: 2007 Mazda 6S 5-door MT 1999 Ford Taurus SE Duratec
|
|
#3
03-10-2005, 08:30 PM
|
|||
|
|||
|
Actually it is pretty easy.
The hardes part is getting a MAF adapter. Draxas is out of business as far as anyone can tell. MAF adapter. 3" aluminum tubing. Silincone adapter from MAF to tubing. 90 degree rubber elbow cone filter 4 clamps go to www.taurusclub.com Oh btw the bling is about the only good thing about it. Mike 
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
