|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
03-09-2005, 01:08 PM
|
|||
|
|||
|
1964 dodge dart 318
Any suggestions as to stroking a 318? Is it even worth doing?
|
|
#3
03-10-2005, 12:59 AM
|
||||
|
||||
|
Re: 318 dodge
yeah, that's all a 360 is, and a 383 is bored 60 over with the same stroke.
__________________
Daily Overhauls Do Get Expensive Dangerous On Days Gears Engage Dead On Day Guarantee Expires Dead Or Dying Gas Eater Department Of Defense Garbage Equipment Dodge Owners Don't Get Excited Don't Overdrive Gutless Engine Drips Oil Drops Grease Everywhere 1995 Dodge Dakota SLT 3.9 V6 1995 Jeep Grand Cherokee Laredo 5.2 V8 4X4
|
|
#4
03-10-2005, 09:46 AM
|
||||
|
||||
|
Re: 318 dodge
I was just educating myself really quick on allpar and it says there that a 360 has a bore of 4.00 and a stroke of 3.58, from 1971 all the way up until they killed it in 2002.
A 383 low block has a bore and stroke of 4.34 and 3.38. A 383 high block has a bore and stroke of 4.03 and 3.75. There are other 383's like the golden commando that has a bore and stroke of 4.25 and 3.38, but I can't find a 383 that has the same stroke as a 360 like you mentioned. I myself was incorrect. You'd have to both bore and stroke a 318 to be able to get 360 cid... http://www.allpar.com/mopar/318.html http://www.allpar.com/mopar/383.html
__________________
My Mopars
|
|
#5
03-11-2005, 09:02 AM
|
|||
|
|||
|
Re: Re: 318 dodge
thank you. I'll take a look at those sites.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
