Need help with my b16 build!! Please Read!!
I need a little help with my build. I have the b16a2 in my 99 si and I recently aquired a Pr3-4 head brand new from the factory along with all its complete components. I have my intake manifold ported and polished as well as a 74/69 taper bored throttle body. I have the standard I/H/E. Since i'm swaping the old pr3-2 head for the new pr3-4 head I wanted to do internal work while i have it open. I wanted to replace the pistons/rings/rods and I'm def. gonna need a new head gasket. I just want to know what i should run as far as pistons/rings/rods and head gasket??? I'm def. going to run a nx wet kit that i already have most likely the 35 or 55 shot. Since the b16a2 motor is already kinda low compression i was thinking about maybe staying with the low compression??? The bottom end itself has about 90,000 miles on it. I just want to make a strong build so that it can handle my 35-55 shot of nitrous without any problems and maybe in the future add a supercharger. Your thoughts, concerns, pros, cons are greatly appreciated. Thanks everyone!
|
Show Printable Version | 
Subscribe to this Thread
03-04-2005, 12:13 AM
