Can't go pass 30mph!

[Luvs2slide]

Hi I had taken off all parts necessary to change all the gaskets for a slight rebuild of the turbo, gaskets and such. After reinstalling all components, It had a steady idle at around 800rpm and oil pressure was good as well as water temp and all. However, while doing a test run, I noticed that my boost gauge did not want to go past 0; so I guess it wasn't building pressure; also the car didnt want to go past approx. 30 mph. Also theres slight smoke seems to be coming from where the turbo exhaust flange and down pipe meet. Any Help and/or suggestions will all be greatly appreciated. Thanks
Sorry this a a repost that was posted previously in the wrong section

[DaMoNe6969]

sounds like you have a bad boost leak..

Check all your hoses, maybe one of them come off or cracked, etc. is it blowing smoke out of the tailpipe?

[Luvs2slide]

Originally Posted by DaMoNe6969

sounds like you have a bad boost leak..

Check all your hoses, maybe one of them come off or cracked, etc. is it blowing smoke out of the tailpipe?

Ok I checked all the hoses and found that the hose that goes out my turbo and into the intercooler piping was half way on. I've been having trouble getting the hose to stay on good but am having no luck. It was blowing smoke out the tailpipe too. I will keep trying until I can find a way to keep the hose secured on there. Thanks for the Suggestion

[DaMoNe6969]

might just need a new clamp..