|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
01-15-2005, 06:40 PM
|
||||
|
||||
Bad Injector? Need Help JDM Motor
I have a d16z6. I replaced all the plugs, wires, control module, cap, and rotor last night. I just drove it for about a mile and it still runs like crap. No. 1 cylinder misses at idle and when I hold the Rpm at about 2000. I pulled the no.1 spark plug and it is completely black. Pulled the rest and look fine. What could be causing this? Do I have a bad injector that is staying open(running that cylinder rich) or could it be a wiring problem to the injector? Please let me know. Thanks
Nick 
|
|
#2
01-16-2005, 03:14 AM
|
||||
|
||||
|
Re: Bad Injector? Need Help JDM Motor
Have you checked compression for #1 cylinder?
__________________
I haven't exactly participated in months and months, but I'm back and oh so excited to give my two cents. :-D
|
|
#4
01-16-2005, 10:29 PM
|
|||
|
|||
|
Re: Bad Injector? Need Help JDM Motor
check your other post.
__________________
99 [email protected] psi si- I voted for the Terminator for Gov. 95 HB- B16a2- SC34@12psi WTB: USDM B16a2 or B16a3 complete short block. pm is the key. FS: B series InlinePro cast mani, PnH RC 550s, and Hondata S2b. pm me.
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
