|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
| JDM Motor & Parts info/chat Discussions on Mugen, Spoon etc. Plus, info on motor swaps (b18 's, b16's h22's etc) and other JDM info! |
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
12-28-2004, 02:52 AM
|
|||
|
|||
PLEASE HELP!!!!! turboin a jdm b16a
I have a 91 honda civic hatchback.I recently swaped out the POS factory motor for a jdm b16a.Now to the good stuff,i went out and bought the new turbonetics fmax kit and installed everything to the T.Now the mofo will not crank for nuthin,(no spark)have the see through msd dizzy cap and a blaster 2 coil.But stil no spark.So if anybody out there can help it would be greatly appreacted.thanx
Last edited by 91b16turbohatch; 12-28-2004 at 02:43 PM. 
|
|
#2
12-29-2004, 11:29 PM
|
||||
|
||||
|
Re: turboin a jdm b16a
I just had this problem with my 93 civic coupe. At first I thought it was the coil but then I talked to one of my instructors about it which is an 11year Honda Tech told me it was the ignition module, spent about $100 and about 5min to replace and it started right up. Also did you start and run the motor before you hooked up the turbo kit if not some wiring might not be hooked up right. But I would try the ignition module first. Good Luck.
Nick
|
|
#3
12-29-2004, 11:35 PM
|
|||
|
|||
|
Re: turboin a jdm b16a
yea tried that but it was an old icm soit could have been the prob.But i'm just gonna send my dizzy back and get a new one
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
