|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Beef Dog Food | IgorSushko.com | Corporate |
|
#1
11-23-2004, 06:42 PM
|
|||
|
|||
|
Check Engine Light On & Wont Start
91 Accord was running fine, went to start check engine light stays on, motor turns over but wont start. Disconnected battery, removed ecm fuse 1/2 hr. Placed jumper wire to get engine code but check engine stays on no matter what i do. will not go off to get code..
|
|
#2
11-23-2004, 07:51 PM
|
|||
|
|||
|
Re: Check Engine Light On & Wont Start
Might need a tow to somewhere that can pull your code (Autozone, for example). Without knowing that ----- it could be anything (well, ALMOST - I guess a flat tire could be ruled out as the cause
 )
|
|
#4
11-23-2004, 08:32 PM
|
|||
|
|||
|
Re: Check Engine Light On & Wont Start
Yeah. The ECM stores some number of previous codes (I don't know how many) not just the current one.
|
|
#5
11-24-2004, 02:23 AM
|
|||
|
|||
|
Re: Check Engine Light On & Wont Start
You can determine the code by installing the jumper in the service connector located under the dash to the right of the glove box. It is a 2 pin connector that when jumpered turns the engine check light into a code light. Read the codes and look in the book. A long on light is a 10 and short light on is 0-9.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
