|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
11-21-2004, 07:25 PM
|
|||
|
|||
|
changing break padds on a 2000?
Yes, This a rather simple question however i would just like to have all of my ducks in a row, before i get started. My question is what size tools will i need to change the break pads on my 2000 contour and are there pads in the back too?
Thanks in advance I'm not sure whether the back breaks are drums or disks i haven't looked yet i was just trying to save time if you already knew. Would you belive that the tools would be metric? Thanks again 
|
|
#2
11-21-2004, 07:48 PM
|
||||
|
||||
|
Remove wheel
Unscrew caliper bolts from knuckle Pull caliper off Replace pads I dont know what size tools since I just figure out what size I need as I do it. As for the backs...are they drums or discs?
__________________
 "The CEG Nazi" www.contour.org 1996 Ford Contour SE - Sold 3.0L V6 and Arizona Dyno Chip Turbo Kit 364 whp, 410 wtq @ 16 psi and only 4,700 rpms. 1999 Tropic Green SVT Contour - Bone stock and MINT
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
