|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
#1
11-14-2004, 09:18 AM
|
|||
|
|||
|
Heater Selector Control
I have a 2001 S-10 ZR2 P/U. With the heater control selector in the feet position I still get air blowing out of the upper section. This happens wherever I have the selector switch. Is the switch bad and how hard is it to replace. Thanks Tery
|
|
#2
11-14-2004, 02:15 PM
|
|||
|
|||
|
Do you get heat from the front vents when you select front vents?
I know most heat/air systems are vacuum controlled, and the default damper setting is the defrost/floor vent. If you have a vacuum leak somewhere it will not allow the dampers to open and close thereby allowing just air from the default defrost/floor vents. I have the same problem with my S-10, but have not found the vacuum leak yet. Also after a few months of this my system quit altogether. I think I have a vacuum leak somewhere AND either my control panel module or blower has went out. Hope this helps a little. Maybe a real expert can provide a more detailed explanation. Robert
|
|
#3
11-14-2004, 02:59 PM
|
|||
|
|||
|
Re: Heater Selector Control
Quote:
|
|
#4
11-14-2004, 03:00 PM
|
|||
|
|||
|
Re: Heater Selector Control
Yes I have heat coming out of all the vents.
|
|
#5
11-14-2004, 11:25 PM
|
||||
|
||||
|
Re: Heater Selector Control
the vacume seal is most likely cracked, its a bi*ch to get to, behind the dash back by the firewall, it opens and shuts the "door" that controlls where the air can go, my old truck does it, only i cant defrost my windsheild in the michigan winter
|
|
#6
11-15-2004, 09:42 PM
|
||||
|
||||
|
Re: Heater Selector Control
Look for a bad vacuum line going to the vacuum ball in the engine compartment.
__________________
1995 Factory Blazer Service Manual for sale, PM if interested.
|
|
 |
POST REPLY TO THIS THREAD |
 |
|
|
