|
| Search | Car Forums | Gallery | Articles | Helper | Air Dried Fresh Beef Dog Food | IgorSushko.com | Corporate |
|
|||||||
 |
 Show Printable Version | 
Subscribe to this Thread
|
|
|
Thread Tools |
|
#1
11-09-2004, 05:20 PM
|
|||
|
|||
|
2001 diamante keyless remote programming
I need to program my remotes for a 2k diamante.
MY FCC-ID IS E4EG8D-522MA OMRON G8D-524M-A If you can help contact me at [email protected] 
|
|
#4
01-06-2005, 06:10 PM
|
|||
|
|||
|
Re: Re: 2001 diamante keyless remote programming
Quote:
|
|
#5
09-26-2005, 09:36 PM
|
|||
|
|||
|
Re: Re: 2001 diamante keyless remote programming
Quote:
|
|
#6
10-09-2005, 07:10 PM
|
|||
|
|||
|
Programming
When remote transmitter added or replaced system malfunction How Note: Entering new remote transmitter codes will erase old codes. All remote transmitters must be programmed together Ensure ignition switched OFF Access data link connector (DLC) driver's side fascia Jump DLC terminal 1 to ground Within 10 seconds: switch ignition fo ACC posistion and then back to OFF position three times Doors should lock and unlock to confirm registration mode Press and release remote transmitter LOCK button Within ten seconds: press remote transmitter LOCK button twice Doors should lock and unlock to confirm registration If registering two remote transmitters, within 1 minute carry out button procedure for second remote. I recently went through this process, keep term 1 grounded until you are done. Exit registration mode by removing term 1 to ground and/or switching ignition to ON hope this helps.
|
|
#7
10-09-2005, 07:46 PM
|
|||
|
|||
|
Re: 2001 diamante keyless remote programming
Quote:
|
|
|
POST REPLY TO THIS THREAD |
 |
|
|
